Maple Burl N/E Bowl

This Maple Burl natural edge wing Bowl is 12 inches wide and 2 inches deep ,finished with wipe-on poly(8 or 9 coats) and sanded between coats with 600 grit.
That little tab on the bottom left holding that piece of the wing on gave me a little trouble ,I needed to use a bit of ca glue to kept that from flying away.

Photo Details

Bob Sesti

Registered: October 2008
Location: Long Island N.Y.
Posts: 193

0

Date: Sun November 15, 2009
Views: 841
Keywords: maple burl ne bowl

Comments

Bill Bolen

I was looking at how thin that tab had gotten. Glad you were able to keep it together. Its an entirely different piece without it. A beauty again. I see with all your HF's you have not forgotten how to do a bowl well...Bill..

#1 Sun November 15, 2009 10:06pm

Bob Sesti

Thanks again Bill,That tab does not make it to the back,it's just bark so it is very thin.It was a miracle it stayed on...........This is from that same tree out east

It's the wood that makes it good

#2 Sun November 15, 2009 10:55pm

Makepeace

Leo Makepeace

Very nice Bob, well kept, must have been a perminent worry while it was spinning. Thumbs Up!

(y)(y)

Ruining lots of good wood to get a few average bits.

#3 Sun November 15, 2009 11:17pm

Don Andrews

Another Stunning piece Bob! :up; Thumbs Up!

Don

#4 Mon November 16, 2009 5:42pm

Brendan McAreavy

I would be lucky to keep that tab on at 4rpm. Another wonderful piece.

#5 Tue November 17, 2009 12:27am

Rev. Doug Miller

Rev. Doug Miller

It's a keeper. Nicely turned piece. 8-)

#6 Tue November 17, 2009 2:12am

Bob Sesti

Thanks again Guys

It's the wood that makes it good

#7 Tue November 17, 2009 9:58pm