Pine and Willow Goblet

I thought I would see how it looked if I drilled a hole in the Pine , made a dowel to fit inside it of Willow and turn a little Gobblet. Only 4" tall but it's a tester. Hope you like it.

Photo Details

Makepeace

Leo Makepeace

Registered: September 2009
Location: Lanzarote, Canary Islands
Posts: 757

0

Date: Tue September 29, 2009
Views: 701
Keywords: pine willow goblet

Comments

Brendan McAreavy

This is how we learn and hone our skills. I have a supply of cheap framing pine that I practice on and do experiments with, most end up in the bin but I'd rather discover my limitations on cheap wood than the special piece I've been saving.

#1 Tue September 29, 2009 5:57pm

Makepeace

Leo Makepeace

Couldn't agree more Brendan. This is framing pine that I had left over after making a workshop out of half of my garage.

Ruining lots of good wood to get a few average bits.

#2 Tue September 29, 2009 6:30pm

Don Leydens

Don Leydens

Very cool! It's always fun trying new stuff. Good idea!

#3 Wed October 7, 2009 12:07am

Makepeace

Leo Makepeace

Thanks Don,
Two bits of scrap so I thought I'd try it.

Ruining lots of good wood to get a few average bits.

#4 Fri October 9, 2009 8:55pm