Tippy platter bowl

8" by 2.5" maple. I made a platter from a video that I watched it has a point on the bottom and won't sit flat. I tried piercing for the first time and made a burnt mess, the only bit I had was one that came with the dremel and wasn't of quality. I also have to get thinner on the wings, but the bottom and sides of the bowl are darn thin, thinner than I have done before so a good start. where do I get good bits that cut rather than burn?

Photo Details

Larry Charlot

Registered: October 2005
Location: Yakima, WA
Posts: 1,225

0

Date: Wed January 17, 2007
Views: 1,072
Keywords: tippy platter bowl

Comments

turnenman

Larry,
I think it looks GREAT and is very different and unique. very well done..

#1 Wed January 17, 2007 3:14am

Grapenut

Forget the problems, Looks good.

#2 Wed January 17, 2007 2:36pm

Rev. Doug Miller

Rev. Doug Miller

I like it too. 8)

#3 Wed January 17, 2007 4:14pm

wheelie

did you happen to see that on a Mick Hanbury dvd?

#4 Wed January 17, 2007 7:21pm

Larry Charlot

Thanks guys, and yes wheelie Mick showed me the way, and 5 more and I will be getting close

#5 Thu January 18, 2007 1:22am

SkyJ

Seems unless you you spend the bucks for the 300,000 bpm on the carving systems, youll have burns! Ive tryied several bits on the dremel and most burn. If it doesnt burn, it takes too much out, too quick, and gets away from me (taking out even more)

#6 Sat January 20, 2007 12:48am