Oh yeah, that's what I was forgetting. . . Top one is 6"w x 2.25"h. Bottom one is 6.25"w x 1.75"h. Both are under a 1/4" thick below the rims. I do some work that is much thinner, but not often. I don't like the fragile feel. To be honest, it's normally accidental if I turn something thinner than an 1/8". If I cut too thin in a spot, I feel obligated to even the rest of the thickness out as well. Luckily as I'm getting a bit better this is happening a lot less.
Poly is the finish.
