Upside down.

Here's a pic in the inverted position. You know what Chris, I think you're right. It looks pretty good like that.

Photo Details

souperman

Registered: May 2006
Location: Smiths, AL
Posts: 125

0

Date: Tue May 30, 2006
Views: 3,610
Keywords: upside down

Comments

Chris Wright

I do this when a piece is on the lathe all the time...been a few cases where I actually stop the lathe, flip the piece and then finish it in the new orientation. Wink

#1 Tue May 30, 2006 4:48pm

souperman

Good thing I put a recess on both sides.

#2 Tue May 30, 2006 4:58pm

Junior Adams

Dude, that is awesome!!! I also like it better upside down!! can't wait to actually hold it! i will mail yours out Tomorrow I promise!!! I just got back in town, and getting everything lined out.

#3 Thu June 1, 2006 4:37am

souperman

Don't feel too bad I didn't make it to the post office on wednesday. But like you said, "Tomorrow I promise!!!" real sorry for the delay.

#4 Thu June 1, 2006 5:51am

Junior Adams

stuff happens homie!!! it's all good!

#5 Thu June 1, 2006 6:25am