Cherry textured plate

I have had the Sorby texturing set for a few weeks, and decided to get some play time on it. Since my shop time has been cut way down the past few months, I figured a platter would not take much time to finish.
This Cherry plate was from part of a crotch that had some cracks because of some pith areas. It has been setting around for a while and I almost threw it out in the burn pile a few times. so I put it on the chuck to try it out, and If it messed up it would be no loss. this tool is very simple to use for the texturing and the patterns are only limited to your imagination.
It measures 11 1/2 wide x 3/4" thick. Finish it wipe on Gel Poly.

Photo Details

Jim Ketron

Registered: January 2006
Location: Weber City, Va.
Posts: 92

0

Date: Mon January 23, 2006
Views: 1,137
Keywords: cherry textured plate

Comments

Rev. Doug Miller

Rev. Doug Miller

Looks pretty nice to me. The texture works well with the piece. Did you texture on the topside of the platter as well? 8)

#1 Mon January 23, 2006 7:46pm

Jim Ketron

Thanks Doug,
That is the top side. I also Did a small part on the bottom too around my sig/date/species.

#2 Tue January 24, 2006 3:59am

Rev. Doug Miller

Rev. Doug Miller

Sorry, no offence meant. Guess I should start asking about the other side. I still like it. 8)

#3 Tue January 24, 2006 6:11am

Jim Ketron

Non taken bud.
I will post a pic of the back.
thanks
Jim

#4 Wed January 25, 2006 5:29am